Canon PIXMA MX7600 네트워크 설정 매뉴얼 - 페이지 19

{카테고리_이름} Canon PIXMA MX7600에 대한 네트워크 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MX7600 43 페이지. Office all-in-one printer
Canon PIXMA MX7600에 대해서도 마찬가지입니다: 보충 설명서 (6 페이지), 설정 지침 (2 페이지), 설정 지침 (2 페이지), 브로셔 (2 페이지)

페이지 인쇄

1 Preparing for Setup

Before installing the MP Drivers in your computer, make sure of the following.

If the installation and adjustment of the machine have not been finished, refer to your setup sheet

to set up the machine properly.

Turn off the firewall function temporarily or change its setting. If you disable the firewall function,

disconnect your network from the Internet.

For information on the firewall function of your security software, refer to its instruction manual or

contact its manufacturer.

Important

After setup is complete, turn back on the firewall function you disabled for setup.

If you connect to a network that is not protected with security measures, there is a risk of disclosing

data such as your personal information to a third party.

Make sure that the configuration of computers, hubs, and other network devices is complete, and

computers can connect to the network.

The configuration and the type of the device vary depending on your network environment. For

details, refer to your device's instruction manual or contact its manufacturer.

Important

A hub and LAN cable are required to connect this machine to a wired LAN. These must be

purchased separately.

Note

In an office setup, consult your network administrator.

Since Mac

OS 9, Mac OS X Classic environments, or Mac OS X v.10.3.8 or earlier are not supported,

do not connect the machine to these.

Log on as an Administrator.

Quit all running applications before installation.

The screens in this manual refer to Mac OS X v.10.4.x installation. Screens may vary depending on the

operation system you are using and also depending on the country or region of purchase.

Setting Up the Machine and the Computer (Macintosh)