Canon PIXMA MX7600 네트워크 설정 매뉴얼 - 페이지 25

{카테고리_이름} Canon PIXMA MX7600에 대한 네트워크 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MX7600 43 페이지. Office all-in-one printer
Canon PIXMA MX7600에 대해서도 마찬가지입니다: 보충 설명서 (6 페이지), 설정 지침 (2 페이지), 설정 지침 (2 페이지), 브로셔 (2 페이지)

페이지 인쇄

2-1 Setting Up for Use over Wired LAN

Important

When the machine has not been connected to the network, to set up the machine to be used from a LAN-

connected computer, the necessary software must be installed on the computer. See "1 Preparing for

Setup" on page 17 and "2 Installing the Software" on page 18 to confirm that the software installation is

complete, then proceed with the procedure below.

On the Canon IJ Network Tool screen,

select LAN connection, then click OK.

If the Canon IJ Network Tool does not start up

automatically, select Library > Printers > Canon >

BJPrinter > Utilities > Canon IJ Network Tool.

Note

If you select USB connection, the Canon IJ Network

Tool will exit without setting up the machine to be used

over wired LAN.

If the screen shown on the right appears, make

sure of the following, then click OK.

– The machine is turned on.

– The machine is connected to the computer with a

USB cable.

– The MP Drivers have been installed.

Select Setup in the pop-up menu, select your

machine's name in Printers, then click OK.

Note

If no printer is detected, click OK. Make sure of the

following, then click Update.

– The machine is connected to the computer with a

USB cable.

– The machine is turned on.

If the machine's network settings are already

configured, the Setup Environment Confirmation

dialog box appears asking for your confirmation to

use the machine with the current settings. You can

proceed with the setup using the current network

settings. To do so, click Use as is. To reconfigure

the network settings, click Reconfigure.

Setting Up the Machine and the Computer (Macintosh)

(continued from step 12 on page 22)