Canon PIXMA MX882 Series 네트워크 설정 매뉴얼 - 페이지 4
{카테고리_이름} Canon PIXMA MX882 Series에 대한 네트워크 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MX882 Series 34 페이지. Using your multifunction with additional computers on your network mac os
Canon PIXMA MX882 Series에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지), 설치 매뉴얼 (23 페이지), 네트워크 설정 매뉴얼 (14 페이지), 네트워크 설정 매뉴얼 (19 페이지)
페이지 인쇄
Access point was not detected. is Displayed
Check
The message appears when no access point is found.
Refer to "The Target Access Point is Not Displayed
(Detected)" on page 2.
Failed to connect to the access point. is Displayed
Check
Check 1
Is WEP key number 2, 3 or 4 of the access point in use?
•
For details on how to check the WEP key number of the access
point, refer to the manual supplied with the access point or
contact its manufacturer.
Set to use WEP key number 1 of the access point, or select a WEP key number by
entering wireless connection settings of the machine directly.
•
For details on how to change the WEP key number of the access point, refer to the manual
supplied with the access point or contact its manufacturer.
•
For details on how to select a WEP key number by entering wireless connection settings of the
machine directly, refer to "Entering the Access Point's Wireless LAN Settings Directly on the
Machine" on page 11.
Check 2
Make sure that the DHCP function of the access point is active.
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Enable the DHCP function of the access point, then configure settings again.
•
For details on how to change the settings of the access point, refer to the manual supplied with
the access point or contact its manufacturer.
Check 3
Are you using an access point that automatically creates WEP keys?
•
For details on the access point, refer to the manual supplied with the access point or contact its
manufacturer.
Check the WEP key (hexadecimal) created automatically on the access point, then
enter it on the machine.
•
For details on how to check the WEP key of the access point, refer to the manual supplied with
the access point or contact its manufacturer.
Check 4
Is the MAC address filtering enabled on the access point?
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Set the access point to accept the MAC address of the
machine.
•
For details on how to change the settings of the access point,
refer to the manual supplied with the access point or contact its
manufacturer.
•
To check the MAC address of the machine, press the Setup
button, then using the { } [ ] and OK buttons, select
Device settings > LAN settings > Confirm LAN settings >
WLAN setting list to check MAC address.