Astralpool QB800 소유자 매뉴얼 - 페이지 12
{카테고리_이름} Astralpool QB800에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astralpool QB800 16 페이지. Robotic pool cleaner
Astralpool QB800에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)
페이지 인쇄
12
Figure 19. Remove the Filter Canister
5.
Separate the two fi lter canisters.
Figure 20. Separate Filter Canisters
6.
Empty all debris from the fi lter canisters, then rinse
canisters, the fi lter support and the cleaner using a
hose.
Figure 21. Wash the Filter Canisters
NOTE: Periodically, remove the fi lter canister and clean
QB800 robotic cleaner
thoroughly with soapy water and a soft bristle
brush.
5.3
Store the Cleaner When Not in Use
The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as
trichlorethylene or its equivalent. Rinse the cleaner
generously using clean water. Do not let your cleaner
dry in direct sunlight near the pool. The cleaner should
be stored on its caddy so that it dries quickly.
1.
Disconnect cleaner from the power source.
2.
Starting at the cleaner head, remove all coils and
tangles from the cable. Lay the cable in the sun to
loosen any tangling memory.
3.
Place the rear wheels on the caddy and position the
cleaner vertically on the caddy base.
4.
Disconnect the cable from the control box. Replace
the protective cap on the control box.
5.
Loosely coil the power cable starting at the cleaner
and moving toward the connection point at control
box. Store the cable by wrapping it around the hook
located on the front of the caddy.
Figure 22. Untangle the Floating cable
5.4
Replacing Wear Parts
5.4.1
Replacing Brushes
The cleaner is fitted with PVC brushes with a ''wear''
indicator.
Owner's Manual