Astralpool S10 설치 매뉴얼 - 페이지 8

{카테고리_이름} Astralpool S10에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astralpool S10 12 페이지.

Care and Maintenance

The AstralPool S10 cleaner cycles on/off with the pool filtration pump, vacuuming and cleaning the pool surface

randomly throughout the pool. The climbing ability of the cleaner is dependent on the pool's shape and available

water flow. If AstralPool S10 is not climbing your walls, ensure the flow is correct by counting wheel speed. Also,

ensure the pools surface is not covered in algae as this slippery surface will affect the cleaner's traction.

During each coverage pattern cycle, the AstralPool S10 cleaner travels both forward and backwards, and pivots to

the right and left. The power scrubbers underneath the cleaner create down force for climbing and stability as well as

directing debris into the cleaner mouth.

Removing the cleaner out of your pool

Always turn the filter pump off and disconnect the head of the cleaner from the leader hose section when you take

the AstralPool cleaner out of the pool.

Always disconnect the AstralPool S10 from the skimmer box before cleaning or backwashing the pool filter. After

cleaning or backwashing, let the filtration system run for at least five (5) minutes to flush out the suction lines before

re-connecting the cleaner.

Adding Chemicals to the Pool

Remove the cleaner from the pool for at least four (4) hours when adding chemicals.

1. Turn off filter pump and remove cleaner from the pool.

2. Push the latch release button on the top of the cleaner.

3. Rotate the top lid assembly back until it clicks into an upward position.

4. Look into engine and remove debris that is present.

5. If needed, slowly push engine paddles forward and/or backwards to move stuck debris to an accessible position

then remove it. When moving the engine paddles, make sure the cleaner tracks are allowed to move freely as

they will turn as the engine paddles rotate.

6. Close engine top and ensure the latch clicks in place.

s10 pool cleaner

Latch Release

Button

Latch Release

Button

Installation Manual