Cognex DataMan 8600V 참조 매뉴얼 - 페이지 8

{카테고리_이름} Cognex DataMan 8600V에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cognex DataMan 8600V 14 페이지.

2. The stand-off snap-fits into the reader.

Calibration

1. Start the DataMan Setup Tool and connect to your reader.

2. Select the Code Quality Settings task pane.

3. Check the box for Verification Enabled under the Verification tab.

4. Place the verifier against the calibration card with the symbol centered below the reader, and squeeze the trigger

5. Continue squeezing the trigger. Calibration can take several seconds

The DataMan Setup Tool displays a graphic guide if the symbol is not precisely aligned with the reader. Adjust

the position and rotation of the reader until the center of the red rectangle lies inside the green rectangle and

there is no more than 10 degrees rotation between the symbol and the reader. The reader beeps once when

calibration is complete.

Getting Started