Doosan HM 630 문제 해결 매뉴얼 - 페이지 5

{카테고리_이름} Doosan HM 630에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doosan HM 630 14 페이지.

HM 500/630/800

① If the spindle is in the process of tool clamping,

manually perform the tool unclamping.

☞ How to confirm the state of tool

unclamping: Check if the spindle emits the

collet air (in MDI or Auto mode), or check if

the button indicator of Tool Unclamp on the

manual OP turns on.

② Repeat briefly pressing the "START" button

until the tool in the changer arm inserts to the

spindle completely.

☞ An excessive pressing may get the

changer arm off of the spindle, causing a

fall of the tool. So you must stop pressing

the button when the tool is inserted nearly

to the end of the spindle.

③ Press the Tool Clamp button to manually

perform the tool clamping on the spindle.

☞ Ensure that the Unclamp button should be

turned off.

④ Repeat briefly pressing the "START" button until the changer arm reaches the home

position and wouldn't move further.

☞ If the main changer arm doesn't move further even by your pressing the

"START" button, this indicates that the main changer arm reaches its home position.

Then, the "2067 Must Be ATC M-Changer Man. 1 Cycle" alarm will be displayed on

the NC screen.

6) Turn the mode selection switch on the ATC manual

OP to "TOOL CHANGE 1 CYCLE", and press the

"START" button to perform the tool changing

automatically. Then, the alarm 2067 will be

released and the ATC home position will be

recovered.

☞ If the Tool Change 1 Cycle operation is not

performed, check the "Conditions of Manual

Tool Change 1 Cycle " below:

HM3digitATCE26