Flybar FB101627 매뉴얼 - 페이지 6

{카테고리_이름} Flybar FB101627에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Flybar FB101627 13 페이지. Ride on bumper car

BEFORE USE

• Remove the two screws from the seat cover and lift out the cover.

• Connect the battery terminal. You must connect the same color wires together: black

connector to the black terminal, red terminal to the red connector. Make sure they are

connected with the correct polarity.

• Replace the seat cover with the two screws and tighten.

CHARGING THE BATTERY

• Plug the charger into a standard 120v wall outlet and the

wire end into the charger port.

• Fully charge the battery for 8-12 hours. Indicator light, located on the charger,

will be Red if vehicle is not fully charged. Once vehicle is fully charged, indicator

light will turn Green.

•

Do not charge the battery for more than 12 hours.

• Check the battery and charger for any signs of wear or damage

before use and do not use if damaged.

• Press the power switch to turn the vehicle on

• Push or pull the control joysticks to move the vehicle

• Release both control joysticks to stop the vehicle completely

WARNING: Close supervision is required when child is operating the vehicle.

FLYBAR_BUMPER_CAR_OWNERS_MANUAL_V2.indd 6

USER INSTRUCTIONS

5/14/21 1:18 PM