Astria Rhapsody54TEN 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Astria Rhapsody54TEN에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astria Rhapsody54TEN 10 페이지. 42- and 54-inch linear direct vent gas fireplaces

페이지 인쇄

Figure 12: Routing wiring

2. If the firebox rear ledge has backlight wire routing holes,

proceed with the instructions in Route and connect

optional firebox liner backlight kit wiring and install lamp

assemblies below.

If the rear ledge does not have backlight wire mounting

holes, follow the instructions detailed in Route and connect

optional firebox liner backlight kit wiring and install lamp

assemblies on Page 10.

Route and connect optional firebox liner backlight kit

wiring and install lamp assemblies

1. Remove the three (3) cover plates in the lower front face

of the back panel. Discard the cover plates, but retain

the screws.

Figure 13: Removing the cover plates, and routing the wiring

2. Route one set of three leads (white/green/black) through

each backlight wire routing hole in the rear ledge

(Figure 12).

3. Route one set of three leads (white/green/black) through

each hole in the lower front face of the back panel

(Figure 13).

INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES

Backlight Wire

Routing Holes

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

7. With one set of three leads, connect the green wire to a

lamp (Figure 14).

Figure 14: Attaching green wire to firebox liner backlight kit

lamp, and inserting lamp into bracket

8. Insert the lamp (with green wire attached) into a bracket

until the spring clip is engaged (Figure 14).

9. Connect the white (neutral) wire and black (hot) wire

(Figure 15).

Figure 15: Attaching black and white wires to firebox liner

backlight kit lamp

10. Repeat the process in step 4 through step 6 for the two

remaining lamp assemblies.

11. Insert the three (3) lamp assemblies in the exact orientation

shown (Figure 16).

Figure 16: Installing the lamp assemblies

12. Secure the lamp assemblies using the six (6) previously

removed screws from the cover plates (Figure 16).