AMES 1000a 사용 설명서 및 안전 지침 - 페이지 9
{카테고리_이름} AMES 1000a에 대한 사용 설명서 및 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AMES 1000a 16 페이지. Ac/dc trms digital clamp meter
페이지 인쇄
Backlight and Worklight
1�
Press the B.L HOLD button for
two or more seconds to turn on the
LCD backlight for 30 seconds�
2�
Press the B.L HOLD button for
two or more seconds again to
turn the LCD backlight off�
Data Hold
The data hold function keeps the current reading on the Display� To activate data hold:
1�
Press the B.L HOLD button and
the reading will be held on the
Display� The
symbol appears�
ncV (non-contact Voltage)
1�
Turn Rotary Switch to
the ncV position�
2�
Move the tip of the clamp close to the
unshielded conductor� If detected
voltage is >110V AC, Meter will beep
and the NCV Indicator will flash�
auto power-Off
If the Meter is not used for approximately 15 minutes, it will automatically turn itself off
to conserve battery power� To turn the Meter back on after auto-off, press the Func
button� To disable Auto Power-Off, hold the Func button while powering the Meter on�
Item 64017
For technical questions, please call 1-888-866-5797.
3�
While in current range modes,
turning the backlight on also
turns the clamp Worklight on�
note: Frequent use of the backlight will
shorten the life of the batteries� Only
use the backlight when necessary�
2�
Press B.L HOLD again
to release the hold�
WarninG! even if no indication is
given, voltage may still be present.
Do not rely solely on NCV detection to
determine the presence of voltage�
Page 9