Flycam FLCM-5000-Q 조립 설명서 - 페이지 5

{카테고리_이름} Flycam FLCM-5000-Q에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Flycam FLCM-5000-Q 11 페이지. Handheld video stabilizer
Flycam FLCM-5000-Q에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

페이지 인쇄

Adding Weights & Positioning for Proper Balance

Continuing the assembly and balance requirements to make your Flycam Handheld Video Stabilizer fully

functional you will note that the base platform has a provision to mount the balance weights in their cups

via a slot found on both sides of the post.

The purpose of the counter weight system is to match the low end of the stabilizer to the weight of the

camera and accessories at the high/top end with the gimbaled handle as the pivot point in between.

The heavier the camera and accessories, the more weights are required to achieve proper balance.

Generally as you add weight to one side of the central post, an equal amount has to be added to the other

side to maintain horizontal balance. However if you are using an offset configuration such as a flip out

viewfinder or off center accessories, extra weights might be needed on the opposite side of the post to

counter act and maintain proper balance.

Total weight fixed to the base platform should be equal to the weight of your camera plus the head and

any accessories.

Horizontal adjustment

platform is made by loosening the retaining

screws and moving counterweight plates

closer to or farther away from the post and

then re-tightening. Therefore, you will

probably need to adjust and re-adjust the

horizontal position to achieve optimum

performance

NOTE: When adding weight to cups, use the

supplied foam spacers as silencers to prevent

metal-to-metal washer noise.

Vertical Adjustment

central post is made by loosening the control

at the base, raising or lowering the center to

the desired location, and then retightening

the vertical control. Do not over-tighten this

control.

on the base

of the telescopic