Akw AKW91275L 설치 및 사용자 설명서 - 페이지 8

{카테고리_이름} Akw AKW91275L에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Akw AKW91275L 12 페이지. Shower screens

Installation

12. Waterproof Seal

On the outside of the screen, apply silicone sealant along the bottom of the compensator or

corner block (for wet floors) and along the bottom of the fixed panel.

On the inside of the screen, apply silicone sealant up the side of the compensator. In general,

Horizontally on the Outside, Vertically on the Inside.

13. Positioning the Magnetic Closing Strip

Place the magnetic closing strip on the inside of the outer door in roughly the right position.

Bring the doors almost to a close to verify the position of the closing strip. Once its position

is set, drill 3 mm pilot holes into the rails through the hole in the part at each end. Remove the

backing paper from the double sided tape and firmly press the strip onto the panel. Fasten the

closing strip to the door using 3.5 x 16 mm countersunk screws (no.6 x ⅝").

F ig. 16

Ensure that the closing strip

Ensure that magnet and adaptor are

is correctly positioned

correctly positioned

Fig. 12.0 and 12.1

Fig. 13.0, 13.1 and 13.2

3 mm

3.0mm

diameter

holes

F ig. 17

Tray Installation

Wet Floor Installation

backing

no.6 x ⅝" csk

No.6 x

" csk

F ig. 18

General: 01905 823 298

doublesided

tape