Amesti Fireplace 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Amesti Fireplace에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Amesti Fireplace 8 페이지.

페이지 인쇄

MAINTENANCE AND CLEANING

MAINTENANCE

Removing ash

Remove the ash from your fireplace once the level reaches about 2 cm below the lower

side of the door's frame.

Push the pieces of log and coal towards the back part of the fire box.

Using a small steel shovel, remove the ash and put it into the ash tray. Placing sand in

the bottom of the ash tray will reduce the risk of fire. Take the ash out of the house and

put it in a safe place. Remember that live coals can burn for up to 36 hours. Untreated

wood ash is an excellent fertilizer for your garden.

Leave at least a 2.5 cm layer of ash as protection for the fire box bottom.

Glass

When the fireplace is cold, clean any stain that may appear on the glass with a damp

cloth. Avoid using any abrasive material that could scratch it.

CREOSOTE FORMATION

AND THE NEED TO CLEAN THE FLUE

Firewood combustion produces acetic and pyro-wood acid, which when combined

with humidity, produces creosote. This can settle on the lower walls of the main

flue pipes, causing the following problem: Combustion chamber and the flue pipes

become blocked, causing the fireplace to malfunction. Under these circumstances, the

ignition will be slow, making it difficult to achieve effective combustion.

In this instance,

clean according to instructions in section "Cleaning Your

Wood-burning Fireplace".

PROBLEM SOLVING

Cause of Smoking Fireplace

No draft due to incorrect ignition

Wet firewood

Blocked flue

Down draft

When opening the door to reload the fireplace, smoke may come out from the

firebox. This can be reduced by reloading it quickly, opening the door only when

needed and using dry wood.

Solution

Light

the fireplace according to the

instructions, using paper and wood chips.

Leave the door slightly open until the fires

heats up. Slowly add logs. Keep the fire

burning.

Replace the firewood with dry wood.

Clean the flue (refer to "Cleaning" instructions).

Extend the flue as explained in the

installation instructions.

Open a window near the fireplace when

starting the fire.

FITTING THE DAMPER

All Amesti fireplaces are equipped with a unique damper. Some models have a steel

damper while others have a Mineral Bioecocaloric ® damper. The damper can be easily

fitted and removed, enabling one to clean with ease or replace in the event that it wears

down. The damper must be fitted in the correct position prior to using the fireplace, as

indicated in the diagrams below:

CARTRIDGE TYPE DAMPER

Oxygen

Tube

Damper

Mounting

Position the damper with the small

holes facing down. Slide onto the

mounting

Slide away from you until it fits over the

oxygen tube

Push the damper until it reaches the

back wall of the firebox.

USE DRY FIREWOOD

MINERAL BIOECOCALORIC® DAMPER

Mounting nº2

Damper

Mounting nº1

Position the damper placing the

narrower side at the bottom of the

fireplace.

Slide away from you until it fits over the

mounting Nº2

Push the damper until it reaches the

back wall of the firebox.