Cognionics Legacy Quick-8 청소 및 관리 - 페이지 3

{카테고리_이름} Cognionics Legacy Quick-8에 대한 청소 및 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Cognionics Legacy Quick-8 4 페이지.

The headset should also be deep cleaned every 50 to 100 uses. The process is as follows:

1. Use a clean cloth, Q-tip, or cotton swab and dab it with alcohol. Do not drench it with

alcohol because the liquid may make contact with the electronics and temporarily

disable the position.

2. Then, remove all of the sensors from the headset if you have not done so. Wipe each

snap socket and the foam on the pod.

3. Finally, allow the headset to completely dry before using it. Allow the headset at least

15 minutes to dry.

If a position stops working as a result of the deep clean, the alcohol may have temporarily

disabled it. Turn off the headset and continue to allow it to dry. The position will work again

once the alcohol has evaporated.

Sensor cleaning and maintenance:

For more instructions on cleaning and caring for the Flex sensors and the Drypad sensors,

refer to the "Flex Sensor Cleaning and Care Guide" document and the "Drypad Sensor

Cleaning and Care Guide". If you do not have these guides, they can be found at:

http://www.cognionics.com/wiki/

NOT APPROVED FOR MEDICAL USE