Astria Fireplaces H9025 설치 지침
{카테고리_이름} Astria Fireplaces H9025에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Astria Fireplaces H9025 2 페이지. Glass media kit
페이지 인쇄INSTALLATION INSTRUCTIONS FOR GLASS MEDIA KITS
FOR USE WITH ENVY CD DIRECT-VENT GAS FIREPLACES
[FIREPLACE MODELS ENVYCD35TEN, ENVYCD40TEN, AND ENVYCD45TEN]
WARNING
HOT GLASS WILL CAUSE BURNS.
DO NOT TOUCH GLASS UNTIL COOLED.
NEVER ALLOW CHILDREN TO TOUCH GLASS.
• Install only when fireplace is OFF and COLD.
• Fireplace surfaces get EXTREMELY HOT!
• The glass on the front of the fireplace reaches EXTREMELY HIGH
temperatures and can cause severe burns if touched. Even after the
gas is turned off, fireplace surfaces remain extremely hot.
• Keep children away from an operating fireplace. Closely supervise children in
any room where a fireplace is operating to prevent contact with glass.
f i r e - p a r t s . c o m
CAUTION
RISK OF PERSONAL INJURY OR PROPERTY DAMAGE.
• Do NOT abuse glass doors by striking or slamming shut.
• Never operate fireplace with glass door assembly removed.
• Handle glass door assembly with extreme care. Replace
damaged glass door assembly with approved replacement
assembly only.
• Use only media approved for use with these fireplaces (as
applicable). Failure to use approved media may result in sooting,
delayed ignition, or other improper fireplace operation, and may
void the warranty.
NOTICE
• READ ALL STEPS BEFORE STARTING INSTALLATION.
• LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.
• All warnings, precautions, and instructions in the Installation
Instructions and Care and Operation Instructions provided with the
appliance also apply to these instructions.
• If you encounter any problems, need clarification of these
instructions, or are not qualified to properly install this kit, contact
your local distributor or dealer.
NOTE: Turn OFF the appliance and allow it to completely cool
before installing this kit.
P900005-06
P/N 900005-06
Rev. NC 10/2014
General Information
This document contains installation instructions for the glass
media kit used with Signature Series ENVY CD direct vent
gas fireplaces.
DO NOT install the glass media until the appliance installation
has been completed, the gas line has been connected
and tested for leaks, and the initial burner operation has
been verified.
Kit Contents
• Glass Media, 5 lb bag (1)
• Installation Instructions (1)
Table 1: ENVY CD Series Glass Media Kits
Accessing the Firebox
INSTALL ONLY WHEN FIREPLACE IS OFF AND COLD!
1. Use the fireplace remote control to ensure the fireplace
is OFF.
2. Turn OFF the gas supply and electrical power to the fireplace.
3. Remove the top louver.
4. Remove the left and right side finish trim gap fillers.
5. Remove the surround trim assembly by detaching it at the
top of the fireplace and lifting it 1 in. to disengage the side
tabs, then pulling it away from the fireplace exposing the
front glass door (Figure 1).
6. Locate the four (4) spring-loaded latches; two above and
two below the enclosure (Figure 2).
7. Release the lower latches, by pulling each handle out
and down to unhook it from the glass door. Lightly press
against the door, to hold it in position, while releasing the
two upper latches.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
Required Tools
Description
Cat. No.
Sky
H9021
Midnight
H9022
Rain
H9023
Sunset
H9024
Cloud
H9025
WARNING
CAUTION
Hot Fireplace Will Cause
Severe Burns
Never Allow Children to
Touch Glass or other Fire-
place Parts
HEARTH PRODUCTS
KITS AND ACCESSORIES
GLASS MEDIA KIT
• Safety Glasses
• Protective Work Gloves
Model
GB-SKY
GB-MIDNIGHT
GB-RAIN
GB-SUNSET
GB-CLOUD