Dor-O-Matic 1993 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Dor-O-Matic 1993에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dor-O-Matic 1993 8 페이지. Concealed vertical rod panic device

Install rod assemblies (continued).

1.6. Check latch operation and rod length adjustment:

1.6.1. Place traveler over rod ends.

1.6.2. Slide traveler up. Top latch should release and hold rods in up position, and bottom

latch should be completely retracted (flush with bottom edge of door).

1.6.3. Move top latch back to locked position. Rods should drop down, locking top latch

and extending bottom latch approximately 1/2".

1.6.4. If necessary, adjust rod lengths for correct operation. Remove traveler after adjustment.

Install cylinder.

Install cylinder. If required, cut cylinder

tailpiece as shown. Heads of cylinder

mounting bolts must be flush with door surface.

Install pinion cam and traveler.

3.1. With cylinder locked and key removed, install cylinder bushing and pinion cam (Figure 3-1).

3.2. Install traveler over rod ends (Figure 3-2).

Cylinder

bushing

Pinion

cam

Position flat spots on

pinion cam as shown

NOTE

Apply a light coating of

Duralub or equivalent

lubricant to prolong

pinion cam life.

Figure 3-1

Tailpiece

Traveler

Figure 3-2

4270101871 Revision 2 Page 3 of 8

3/64"

15/64" dia. drill

5/16" dia. c'sink

3/16" from end of cylinder

tailpiece to surface of door