Canon 8600F - CanoScan 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} Canon 8600F - CanoScan에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon 8600F - CanoScan 12 페이지. Canon canoscan 8600f quick start guide
Canon 8600F - CanoScan에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (29 페이지)

페이지 인쇄

1. Scanning Film

Scanning Film

This scanner can scan 35 mm film (film strip or slide) and 120 format film. Follow the procedure below when

scanning film. Make sure that the FAU Cable is connected to the FAU connector on the back of the scanner

Remove the protective sheet from the

document cover.

Press and hold the lever at the top of the protective

sheet while you

pull the sheet outward and

detach it.

• Store the protective sheet in a safe place so that it will not get bent or broken.

• Always put the protective sheet back when you are not scanning film to protect the

light source in the document cover.

Insert the film into the Film Guide.

• Use a blower brush to remove any dust from the film, which will affect the image quality,

and take care to hold the film by its edges to avoid transferring dirt or fingerprints to it.

• Do not block the calibration slot on the Film Guide when scanning film. Colors will not

be scanned correctly if the calibration slot is obstructed.

• Close the Film Guide securely. Press lightly until it clicks into place.

35mm Film Strip

Open the film holder on the film guide, place the film face down and close the film holder.

Align the Film Guide's tab with the FILM symbol on the document glass of the scanner.

• Place a black piece of paper over any gap to shield the light if you are inserting a film

strip with 5 or fewer frames, or if the edge of a scanned image appears whitened.

• Ensure that there is no gap between the edge of the film and the film guide on the

side near the calibration slot.

Film Holder

Calibration Slot