Canon 8800F - CanoScan - Flatbed Scanner 빠른 시작 매뉴얼 - 페이지 11
{카테고리_이름} Canon 8800F - CanoScan - Flatbed Scanner에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon 8800F - CanoScan - Flatbed Scanner 32 페이지. User guide
Canon 8800F - CanoScan - Flatbed Scanner에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (16 페이지), 브로셔 (10 페이지), 사용자 설명서 (2 페이지), 서비스 매뉴얼 (28 페이지)
페이지 인쇄
35mm Slides
Align the Film Guide's tab with the FILM symbol on the document glass of the scanner.
Place a slide or slides face down (correctly viewed from
below) in the Film Guide as shown in the diagram to the
right.
120 Format Films
Open the film holder on the film guide, place the film face
down and close the film holder.
Align the Film Guide's tab with the FILM symbol on the
document glass of the scanner.
• Leave a gap of 5 mm or greater between film
strips when placing two or more on the
document glass.
• Ensure that there is no gap between the
edge of the film and the film guide on the
side near the calibration slot.
Using a Film Retainer Sheet
Curled film strips can stick to the document glass
and cause a pattern of rings called Newton Rings to
appear on the scanned image. If this occurs, scan
using the supplied film retainer sheet as shown in
the diagram.
(A) Scan with the film retainer sheet inserted
beneath the film.
(B) If Newton Rings still appear after following
Instruction (A), turn the film strip over and place
it in the film holder with the film retainer sheet on
top so that the film edges are held down for
scanning. Then preview the image in ScanGear
and click the [Mirror] button to reverse the image
before initiating the final scan.
To avoid damaging the film, always place the
glossy side (the side without an illustration)
of the film retainer sheet against the film.
3
Close the document cover.
(A)
Film retainer
sheet
With its glossy side
facing upward, slip
the film retainer
sheet under the film.
(B)
Hold the film edges down
by placing the film
retainer sheet on top with
its glossy side facing
downward.
Scanning Film
Film Holder
120 Format Film
9