ASTRO HVB 21 운영 매뉴얼 - 페이지 15
{카테고리_이름} ASTRO HVB 21에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASTRO HVB 21 20 페이지. Broadband amplifires
페이지 인쇄
Configuration
2
1
5
Operating manual HVB 21, HVB 31 a. HVB 32 -
First configure the amplifier for the transmission of forward signals:
T
ASK
1.
Remove the housing cover by loosening the cover screw.
2.
When the devices are delivered, the HVB 21, HVB 31 and HVB
32 amplifiers have an attenuator (0...15 dB) [1] and a tilt equal-
iser (0...15 dB) [2] (see left) in the input, which are screwed in.
They can be used to set the desired attenuation and equalisa-
3
tion. (Input and output are protected against overvoltage.)
3.
You can also set a pre-equalisation of 0 or 7 dB between the
amplifier stages by inserting the
jumper [3] accordingly.
ATTENTION
be exceeded! (maximum input level = output level minus the
set gain for 1006 MHz)
R
:
ESULT
The device is now configured for the transmission of forward sig-
nals.
To transmit return signals, the amplifier must be configured accord-
ingly.
The following describes how to configure the amplifier for the trans-
mission of return signals:
T
ASK
1.
When the device is delivered, the attenuator (0...15 dB) [5] is
screwed in and must be set according to the cable network
specifications.
R
:
ESULT
The device is now configured for the transmission of return signals.
ATTENTION
in the return path input screwed in to avoid a possible
network malfunction or the destruction of the device upon
being connected. This setting must not be changed in
networks that do not use a return path!
Version 01-2021A
:
The maximum operating level must not
:
The device is delivered with the attenuator
page 15