ASTRO HVB 31 운영 매뉴얼 - 페이지 13
{카테고리_이름} ASTRO HVB 31에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASTRO HVB 31 20 페이지. Broadband amplifires
페이지 인쇄
Installation
4
2
5
Operating manual HVB 21, HVB 31 a. HVB 32 -
You can install the amplifier either using wall plugs in a masonry
wall or on a perforated or wooden panel using wood screws or sheet
metal screws.
The following describes how to fix the amplifier to a masonry wall:
P
:
REPARATION
Drill two holes in a vertical masonry wall and insert the supplied wall
plugs into the holes.
The required distance between the two boreholes is 100 mm.
The following describes how to install the device:
T
ASK
1.
Place the back of the device against the installation surface so
that its drill holes are exactly above the two wall plugs. The
device inputs and outputs must point downwards.
2.
Screw the device into place using the supplied screws (drill
holes [4] in the device, see left).
R
:
ESULT
The module is now installed and can be connected.
The following describes how to install the amplifier on a perforated
or wooden panel:
P
:
REPARATION
Drill two holes in a wooden panel or use the existing boreholes in a
perforated plate.
The required distance is 130 mm.
The following describes how to install the device:
T
ASK
1.
Place the device on the installation surface so that the lugs on
the outside of the housing are exactly over the boreholes in the
panel. The device inputs and outputs must point downwards.
2.
Screw the device in place using wood screws or sheet metal
screws (drill holes [5] in the device, see left).
R
:
ESULT
The module is now installed and can be connected.
Version 01-2021A
Installation
page 13