DORAL DO-1662S-White 사용 설명서 - 페이지 6

{카테고리_이름} DORAL DO-1662S-White에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DORAL DO-1662S-White 8 페이지.

페이지 인쇄

F: TROUBLE SHOOTING

Please check the followings before having the machine repaired.

PROBLEMS

Not hot or cold

water

No water

running out

from taps

Leakage from

bottle supporter

Noisy operation Not placid installation

G: CLEANING

To avoid accident, cut off the power supply before operation according to the following

instruction.

1.The machine had been disinfected before departed from factory.

Cleaning the dispenser prior to installing a full bottle of water for the first time.

2.Cleaning and draining instruction:

a) Before cleaning, make sure the power switch in the O(off) position and unplug the water

dispenser.

b) Vertically insert the bottle into the supporter on the top of the machine.

c) Turn on all the taps in turn for 3 minutes after the water outflow, which completes the internal

pipeline flushing.

d) Removed the water bottle from the dispenser.

e) Place a large bucket beneath the drain outlet. Remove the drain cover and allow water to

drain.

f) After cleaning, replace the drain cover and you can use the machine.

Attention: The dispenser heats water to a temperature of approximately 85°C. It can cause

severe burns. Please operation it carefully.

3. Sanitizing

The machine should be disinfected with the disinfectant separately bought from drugstore or

marketplace according to the instruction manual of the disinfectant and then clean it with water

(see cleaning and draining instruction). Generally this should be done every three months.

4. To remove mineral deposits:

Mix 4 liters water with 200g citric acid crystals, inject into the machine and make sure the water

can flow out of the hot water tap. Switch on the power and heat it about 10 minutes, 30 minutes

later, drain off the liquor and clean it with water for two or three times. Generally this should be

done every six months.

Never disassemble this machine by yourself to avoid danger from damaged machine.

POSSIBLE CAUSES

1. Over consumption of hot or

cold water in short time.

2. No power supply

1. Empty bottle

2. Inlet of bottle supporter

blocked by bottle seal

Broken bottle

ELMINATION

1. Just wait a moment, then hot or

cold water is available again.

2. Connect plug to socket, turn on

heating or cooling switch.

1. Replace it with another one.

2. Clean out wasted paper & bottle

seal, install bottle again

Replace it with a new bottle

Place the machine on placid &

solid surface