Doran 8000 사용자 설명서 - 페이지 6

{카테고리_이름} Doran 8000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Doran 8000 6 페이지.

Note: 8000IS users, refer to the 8000IS Manual.

The 8000 is internally equipped with a self-contained rechargeable, sealed, gelled-

electrolyte battery and charging circuit. The 8000 is designed to run continuously for

40 hours** on a fully charged battery.

The charging circuit will fully charge the battery in approximately four hours. To

charge the battery, simply plug the line cord into a standard 115V (220V optional)

wall outlet.

The 8000 can be used while recharging the battery. A full recharge takes place in

four hours, whether the 8000 is on or off. The 8000 can be used with the AC

charger cord plugged in on a continuous basis.

If an AC power failure occurs, the 8000 battery takes over to provide uninterrupted

scale operation for up to 40 hours.

The flashing "BATT" indicator indicates that the battery is in need of recharging.

When the battery is too low to run the scale, the 8000 simply turns off and will not

operate again until the battery is recharged.

Once "BATT" begins flashing, there will be approximately one more hour of battery

life before the scale shuts down. The 8000 remains accurate and useable even with

"BATT" flashing.

Note: Battery life can vary depending on the following:

1. The number of load cells connected to the indicator.

2. The operating temperature the indicator is used at.

3. Whether or not the battery is fully charged after each low battery ( flashing

"BATT" indicator ) event.

Model 8000 User's Manual

BATTERY OPERATION

( **with only 1 350 ohm load cell. )