ASTRO DEVICES Nexus II 매뉴얼

{카테고리_이름} ASTRO DEVICES Nexus II에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASTRO DEVICES Nexus II 4 페이지. Using with skysafari plus/pro

Using Nexus-II with SkySafari Plus/Pro

This document describes how to setup your Nexus-II with your iPhone/iPad/iPod

touch using default factory settings.

1. Please go to 'Setting' then 'Wi-Fi' on your iPhone/iPad/iPod touch. You will see

'NexusII_XXXXX there (where XXXXX is the serial number of your Nexus found on

the back of Nexus), select it.

Nexus-II will be connected in a few moments.

2. Run SkySafari Plus/Pro, go to 'Settings' -> 'Telescope' -> Setup'.

3. Set 'Mount Type' to 'Alt-Azimuth Push-To' for example.

Under 'Communication Settings': set the 'IP address' to

10.0.0.1, 'Port Number' to 4060. Set 'Scope Type' to 'Basic

Encoder System'.

The 'Readout Rate' can be either set to '10 per second' for

reduced lag or it can be set to default '4 per second'.

Under 'Encoder Steps Per revolution' set both 'RA/Azm' and

'Dec/Alt' to the number of steps per revolution of your

corresponding encoders (10000 in this example). Please

turn off 'Get Automatically'.

www.astrodevices.com

Page 1 of 4