Canon ImageCLASS MF4270 시작 설명서 - 페이지 13

{카테고리_이름} Canon ImageCLASS MF4270에 대한 시작 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon ImageCLASS MF4270 38 페이지. Canon all in one printer user manual
Canon ImageCLASS MF4270에 대해서도 마찬가지입니다: 시작 설명서 (36 페이지)

페이지 인쇄

1. Network Connection

Connect the Power Cord, Turn On the Machine

Connect the power cord into the rear socket on the back side of the machine and the wall outlet, and

press the [I] side of the main power switch (A) to ON.

The machine enters the standby mode.

The LCD display turned off:

●

The machine may enter the sleep mode while you are setting up the machine. Press

on and continue the setup.

<CLOSE COVER/TONER COVER> is displayed:

●

Make sure that the toner cover and scanning platform are closed properly. (See "Install Toner Cartridge, " on p. 6.)

<SET PAPER AGAIN/SET TONER AGAIN> is displayed:

●

Check the installation of the toner cartridge and the placement of the paper. (See "Install Toner Cartridge, " on p. 6 and "Set Up the

Paper Cassette and Load Paper, " on p. 9.)

This product emits low level magnetic flux. If you use a cardiac pacemaker and feel abnormalities, please move away from this

product and consult your doctor.

–

If you loaded paper other than A4, make sure to set the correct paper size in the machine. (See Chapter 2, "Document and Paper, "

in the Reference Guide.)

–

Any data stored in the memory, including received fax documents, will be deleted if you turn off the main power switch of the

machine.

–

During electrical storms, disconnect the power cord from the power outlet. (Please note that received documents stored in the

machine's memory may be lost when you unplug the machine.)

–

Whenever you unplug the machine, wait at least five seconds before you plug it in again.

–

Do not plug the machine into an uninterruptible power supply (UPS).

Ex.

1 0 0 %

A 4

T E X T / P H O T O

Set Up the Machine

[Energy Saver] to turn the machine back