AIR GAP TAP-A-FLOW AG250-103 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} AIR GAP TAP-A-FLOW AG250-103에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AIR GAP TAP-A-FLOW AG250-103 2 페이지. Kitchen pedal with constant flow lock stainless steel finish

페이지 인쇄

1 – Pedal assembly

1 – Top mounting plate

2 – #10 Mounting screws

The AG250-103, in combination with

AG250-002 valve, provides hands-free

faucet operation.

AG250-103 has constant lock option.

Valve is ordered separately.

Please read the instructions once through before starting.

PEDAL INSTALLATION INSTRUCTIONS

Apply top mounting plate at

the edge of the cabinet and

mark position of mounting

screws.Drill two holes for #10

screws. (13/64"). (FIG.1)

Measure 1-3/4" from the

bottom of cabinet aligned with

the top mounting plate,drill 1"

hole under the cabinet plate.

(FIG.1)

Pass cable from the AG250-002 valve through the 1"

opening under the cabinet plate and connect it to the

pedal AG250-103.

Unscrew the front nut (1) on the valve cable and insert the

cable (4) through the slot on the back side of support

bracket AG250-103 pedal. The rear nut (3) remains at the

end of the thread (2). Adjust cable holder (2) for proper

pedal operation and secure its position with nuts (1) and

(3).Control cable (4) should be snug. (FIG. 2)

AG250-103

Installation Procedures

LIST OF PARTS ENCLOSED

FIG. 1

FIG. 2

Openings for

#10 screws

Verify that valve actuating cable is inside the valve

receptacle. (FIG.3)

1-3/4"

1" Diameter

FIG. 3

Insert valve cable end T-bar (5) into the pedal

lever (6). (FIG. 2)

Use provided #10 screws to attach the pedal.

(FIG.4) Pedal position can be adjusted using

four screws (7) on side of pedal assembly.

(FIG. 2)

FIG. 4

-OVER-

AG250-103

Pedal

AG250-002

Cold/Hot Potable Water

Mechanical Valve