Coiltek CS-5103 운영 매뉴얼 - 페이지 14

{카테고리_이름} Coiltek CS-5103에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coiltek CS-5103 17 페이지. Ultrasonic sensors

Cable Connections

The two boards in the CS-5000 V2 and CS-5100 V2 controls are connected by nine-conductor cable.

The colored wires on each end of the cable are connected in the same order, the only difference being

that one end of the cable will have longer green and brown wires than the other. This end of the cable

will connect to the range card with the longer wires connecting to the LED mounted in the endcap of

the boom. Please follow the diagrams below to wire your unit.

Range Card & Endcap

Features of the CB-5101R-2 Range Card

This latest update of the Coiltek range card is form, fit and function compatible with the

CB-5101R, CB-5101R-1 versions (above). All installation procedures and precautions associated with

previous versions apply, including removal of the 7 pin connector (above).

The sensitivity potentiometer, which governs the amount of echo received, has been repositioned such

that adjustment may be made by removing the case end cap (figure below). On previous cards, this pot

was mounted flat so that adjustment required removing the card from the case or stand boom. Adjust

clockwise to increase sensitivity, counterclockwise to decrease.