Flying Industry Development S2U-DC12-ANT2 빠른 매뉴얼 - 페이지 2

{카테고리_이름} Flying Industry Development S2U-DC12-ANT2에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Flying Industry Development S2U-DC12-ANT2 3 페이지. Rf wireless remote control radio controller / transmitter & receiver

페이지 인쇄

Press and hold small button: Turn on relay 2 (connect B and C, disconnect A and B)

Release small button: Turn off relay 2 (disconnect B and C, connect A and B)

Setting control mode Latched: Disconnect Jumper-1 and Jumper-2.

Control mode Latched: Press -> On, another relay Off; Press another button -> Off.

Press big button: Turn on relay 1 (connect B and C, disconnect A and B)

Turn off relay 2 (disconnect B and C, connect A and B)

Press small button: Turn on relay 2 (connect B and C, disconnect A and B)

Turn off relay 1 (disconnect B and C, connect A and B)

Setting control mode Momentary + Toggle: Connect Jumper-1 and Jumper-2.

Control mode Momentary (Channel 1): Press -> On; Press again -> Off.

Press and hold big button: Turn on relay 1 (connect B and C, disconnect A and B)

Release big button: Turn off relay 1 (disconnect B and C, connect A and B)

Control mode Toggle (Channel 2): Press and hold -> On; Release -> Off.

Press small button: Turn on relay 2 (connect B and C, disconnect A and B)

Press small button again: Turn off relay 2 (disconnect B and C, connect A and B)

We have learned remote control to the receiver. If you don't want the receiver to work with the remote control, you can delete all codes of remote

controls, which are stored in the receiver.

Operation: Press and hold the button of receiver until signal LED flashes slowly; release the button, LED keeps slow flash. That means all stored

codes have been deleted successfully.

Learning the button of remote control:

1) Press the button of receiver; signal LED on the receiver keeps shining. The receiver enters into status of LEARNING.

2) Press any one button on remote control. If signal LED flashes quickly 15 times and turns off, it means learning is successful.

3) When receiver is in the status of LEARNING, press again the button of receiver, signal LED turns off, learning process will be discontinued.

4) The receiver can learn several remote controls with different codes.

Application Circuit

Signal LED

Power LED

Relay 2

Lamp 2

DC0~28V / AC110~240V

A, B=Normally Closed; B, C=Normally Open.

Button

Antenna

Relay 1

Lamp 1

Power supply

SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD

Http://www.caymart.com

Application: For DC12V motor or lamp