Ametek Gemco 1996 Ram-Set 설치 및 유지 관리 매뉴얼 - 페이지 13
{카테고리_이름} Ametek Gemco 1996 Ram-Set에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ametek Gemco 1996 Ram-Set 20 페이지. Automatic press shut height controller
페이지 인쇄
Once the die number is selected and <ENT> has been depressed, the preprogrammed counter balance value and shut
height value for that die # will be displayed to be verifi ed. Depressing <ENT> again will confi rm and enable a drive to the
selected shut height and the counter balance for that die will be implemented.
Upon system initialization, the counter balance override value is set to zero. If power is shut down, once power is restored,
the last counter balance utilized before shut down is implemented and displayed.
3.1 RS485 Protocol and Interface
The RS485 option provides the user with the mechanism to establish a communication link between the 1996 Ram-Set and any
remote system incorporating RS485 capability. The remote system could be a programmable controller, or any computer based
operating system.
Through use of this communication link, all Ram-Set functions can be monitored or changed. Up to 32 systems, including the
host computer can be tied into this link.
System Protocol
The Ram-Set is factory set for 9600 baud rate, 8 bit word length, 1 stop bit, parity off, and parity even.
To change baud rate:
The following baud rates are available: 150, 300, 600, 1200, 2400, 4800, or 9600.
The remaining protocol information is entered by:
The value is a (4) four digit code relating to parity odd/even, parity enable/disable, bit data, transmit with or without leading zeros
omitted.
X
X
X
7 = seven bit data, 8 = eight bit data
0, 1 and 2 transmits 4, 5, 6 characters with leading zeros omitted
4, 5 and 6 transmits 4, 5, 6 characters without leading zeros omitted
Each Ram-Set must have it's own unique address location from 00 to 99.
The host computer (bus master) must have an address on the same format as the Ram-Set. Program by:
Note: The address functions are only accessible through the keypad. (F-232, 233, 234, 235).
Serial programming follows the keypad entry format.
F
-
2
-
3
-
2
F
-
2
-
3
-
3
X
0 = even parity, 1 = odd parity
0 = disable parity, 1 = enable parity
F
-
2
-
3
-
F
-
2
-
3
-
Installation and Maintenance Manual
Chapter 3: Programming and Operating Instructions
-
ENT
-
Value
-
-
ENT
-
Value
-
4
-
Value
-
ENT
5
-
Value
-
ENT
ENT
ENT