Astro Pneumatic Tool 30570 매뉴얼 - 페이지 7
{카테고리_이름} Astro Pneumatic Tool 30570에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astro Pneumatic Tool 30570 9 페이지. 20v 7" brushless variable speed rotary polisher w/ 2 batteries
페이지 인쇄30570
Model:
d) Use special care when working corners,
sharp edges etc. Avoid bouncing and
snagging the accessory. Corners, sharp
edges or bouncing have a tendency to snag
the rotating accessory and cause loss of control
or kickback.
e) Do not attach a saw chain woodcarving
blade or toothed saw blade. Such blades
create frequent kickback and loss of control.
SAFETY WARNINGS SPECIFIC FOR
POLISHER OPERATIONS
Do not allow any loose portion of the polishing
bonnet or its attachment strings to spin freely.
Tuck away or trim any loose attachment strings.
Loose and spinning attachment strings can
entangle your fingers or snag on the workpiece.
Warning: Some dust created by power
sanding, sawing, grinding, drilling, and other
construction activities contains chemicals
known to cause cancer, birth defects or other
reproductive harm. Some examples of these
chemicals are:
a) lead from lead-based paint
b) crystalline silica from bricks and cement
and other masonry products, and
c) arsenic and chromium from
chemically-treated lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic
particles.
Product Type:
20V 7" BRUSHLESS VARIABLE SPEED
ROTARY POLISHER W/ 2 BATTERIES
INSTRUCTION
Bale Handle
Arbor
Lock
Warning: Recharge only with the charger
specified for the battery. For specific charging
instructions, read the operator's manual supplied
with your charger and battery.
Removing/Inserting the battery to remove the
battery, push in the release buttons and pull the
battery pack away from the tool.
Always remove battery pack before changing or
removing accessories. To insert the battery, slide
the pack into the body of the tool. Make sure it
latches securely into place.
To reduce the risk of injury, always use a side
handle when using this tool. Hold securely.
INSTALLING THE HANDLE (FIG. 1)
a) Position the handle in the position (left or
right orientation) that offers best control.
b) Slide the handle around the front of the tool
and up onto the body of the tool.
c) Fit the handle into both handle sockets.
d) Select one of the three angle positions that
offers best control, forward or back.
e) Insert the hex screws into each side of the
handle and tighten securely with the hex
wrench provided.
FIG. 1
Page 7
Electronic
Speed Control
On/Off Switch
Detachable
Air Inlet Screen
Hex Screw