Astro Pneumatic Tool 1812L 매뉴얼 - 페이지 3
{카테고리_이름} Astro Pneumatic Tool 1812L에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astro Pneumatic Tool 1812L 4 페이지. 1/2" super duty impact wrench
페이지 인쇄Model:
The oil and water extractor should not be mounted on or near the air
compressor.
The temperature of air is greatly increased during compression. As the
air cools down to room temperature, in the air line, on its way to the Air
Power Tool, the moisture contained in it condenses. Thus, for maximum
effectiveness, the oil and water extractor should be mounted at some point
Pitch pipe back toward air receiver
Compressor unit
Drain
Daily
1812
1812L
- 3" Anvil
SUGGESTED AIR LINE CONNECTION
PIPE SIZE, I.D. (Inches)
Air Flow
CFM
10
20
30
40
50
70
Oil and Water Extractor should be at least 25 ft. from the compressor. Further if possible.
Product Type:
1/2" SUPER DUTY IMPACT WRENCH
in the air supply system where the temperature of the compressed air in
the line is likely to be lowest. Air lines must be properly drained daily.
Each low point in an air line acts as a water trap. Such points should be
fitted with an easily accessible drain. See diagram below. Pitch all air
lines back towards the compressor so that condensed moisture will flow
back into the air receiver where it can be drained off. Drain daily.
Length of Pipe (feet)
150
200
50
100
3/4"
1/2"
3/4"
3/4"
3/4"
3/4"
3/4"
1"
1"
3/4"
3/4"
1"
1"
1"
1"
1"
1"
1"
1"
1"
1-1/4"
1-1/4"
1"
25 FEET OR MORE
Page 3
Install drain at
each low point
Oil and Water
Drain
Daily
-
Extractor
Drain
Daily