Canon L1 설치 절차 매뉴얼 - 페이지 13

{카테고리_이름} Canon L1에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon L1 48 페이지.
Canon L1에 대해서도 마찬가지입니다: 사용 설명서 (37 페이지)

3) Mount the fixing plate [I] at the front and the fixing

2.1 .2

Checking the HeightITilt

plate [2] at the rear using two screws each [3] (bind-

Check the heightltilt of the finisher.

ing; M4 x 6).

If the fixing plate [I] cannot be attached because

the blanking part on the host machine's left cover is

small, remove the following parts:

Host machine's front cover (one blanking rubber

and two screws)

Host machine's left cover (four screws)

Next, attach the fixing plate [l] and then attach the

cover in place.

Check to make sure that the host machine is off

and its power plug is not connected to the power

outlet.

Depending on the condition of the floor of the site

of installation, you may need to adjust the height

or the tilt of the finisher. A discrepancy in the

height or tilt of the finisher can well lead to fre-

quency jams. Check the heightltilt as follows,

and make adjustments as necessary.

1) Make the connection by matching the pin found on

the fixing plate (rear) of the host machine against

the hole in the finisher.

Check to be sure that there is no gap between the

finisher and the host machine.