Canon L1 설치 절차 매뉴얼 - 페이지 31

{카테고리_이름} Canon L1에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon L1 48 페이지.
Canon L1에 대해서도 마찬가지입니다: 사용 설명서 (37 페이지)

3.2

Making Adjustments

3) From the back of the front cover, remove the fixing

screw, and detach the spanners [I].

3.2.1

Adjusting the HeightITilt

If the difference in height between the puncher unit

and the host machine or the tilt is not as indicated,

make adjustments as follows; be sure to adjust the

height before adjusting the tilt:

Preparing for Adjustment

In the case of the Finisher-AEl, you may need to

remove the auxiliary ring and the rear foot cover of

the finisher before adjusting the height; be sure to

remove the auxiliary ring without disconnecting the

finisher from its host machine to prevent the finish-

er from tumbling over.

<Finisher-AE 1 >

1) If the height at the rear must be corrected, remove

the auxiliary ring and the leR rear foot cover.

Remove the four screws [I], and detach the auxilia-

ry ring [2]. Remove the screw [3], and detach the

leR rear foot cover [4].

1) Open the front cover; then, from the back of the

front cover, remove the fixing screw, and detach the

spanners [I].

2) Remove the three screws, and detach the front cov-

er. (Skip this step if it has already been removed.)