Canon L1 설치 절차 매뉴얼 - 페이지 9

{카테고리_이름} Canon L1에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon L1 48 페이지.
Canon L1에 대해서도 마찬가지입니다: 사용 설명서 (37 페이지)

1.4

Unpacking and Checking

the Components

1.4.1 Unpacking (Finisher)

MEMO:

The machine is packed using tape and cushioning

materials to be protected against vibration and

shock during transit. Be sure to remove them be-

fore starting to install the machine. (It is a good

idea to store away the removed tape and cushion-

ing material for possible relocation of the machine,

e.g., to a new site or for repairs.)

1) Take out the accessory box from the shipping box.

2) Lift the finisher together with its cushioning base

(Styrofoam). Be sure to work in a group of two per-

sons.

If you shift up the finisher on its side, you would

likely deform or damage the machine. Moreover,

in the case of the Saddle Finisher-AE2, the force

applied to the front cover [l] can deform the

hinge.

The finisher is rather heavy. (Weight: Finisher-

AE1: 43.2 kg, Saddle Finisher-AE2: 73.2 kg) Be

sure to work in a group of two persons. Particu-

larly when moving it over a step on the floor, be

sure to take full care not to let it tumble over.

At this point, do not remove the four cushioning

materials (Styrofoam) from the finisher. Otherwise,

you would likely deform some areas of the ma-

chine.

3) Remove the cushioning material (Styrofoam) from

the upper cover.

4) Slightly lift the front and rear casters, and remove

the cushioning material (Styrofoam). Be sure to

shift up the finisher by holding the upper left cover

P I

(gray area).

F-I -1 I