COINTERRA TERRAMINER 사용자 설명서 - 페이지 5

{카테고리_이름} COINTERRA TERRAMINER에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. COINTERRA TERRAMINER 18 페이지.

Connecting the TerraMiner

Network

Before powering up the TerraMiner it should be connected to a permanent broadband Internet

connection by plugging it into a network router or switch using a standard CAT5e network cable. The use

of wireless or cellular connections is not recommended. The TerraMiner should always be properly

secured on the network; please see the Security Advisories section for details.

Power

The TerraMiner incorporates dual power supplies

12-5

Amps. Depending on the location's operating voltage and the circuits' amperage capacity, each

power supply may need to be connected to a separate circuit. The approximate amperage required for

each power supply can be calculated by dividing the peak wattage by the voltage (for example

1300W ÷ 120V = 11 amps per supply in the USA, or 1300W ÷ 230V = 5.7 amps in Europe.)

Do not connect the TerraMiner to power extension cords, power strips, multi-

outlet adapters or other power connections that are not rated to deliver at least

15 amps (20 amps recommended) per power supply.

The labels on the side or rear of the TerraMiner's chassis indicate the order in which the power supplies

should be connected:

To boot up the TerraMiner:

Connect both power cords within 3 seconds of each other in the designated order (if they are not



both powered up within this time it is possible that the controller card will not recognize both

GoldStrike boards inside the TerraMiner.)

After a few seconds, the CTR1 LED on the front of the TerraMiner should first turn orange.



When the system has completed booting, the CTR1 LED will turn green to indicate that the



TerraMiner is operational, or red if there is a network connectivity issue (such as a disconnected

network cable.)

TerraMiner User Guide

which each operate at 110-240VAC, 50-60Hz