Ametek Magnetrol SOLITEL 설치 및 운영 매뉴얼 - 페이지 2

{카테고리_이름} Ametek Magnetrol SOLITEL에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ametek Magnetrol SOLITEL 13 페이지.

페이지 인쇄

Read this Manual Before Installing

This manual provides information on the Solitel

Vibrating Rod Level Switch. It is important that all

instructions are read carefully and followed in sequence.

Detailed instructions are included in the Complete

Installation section of this manual.

Conventions Used in this Manual

Certain conventions are used in this manual to convey

specific types of information. General technical material,

support data, and safety information are presented in

narrative form. The following styles are used for notes,

cautions, and warnings.

Notes

Notes contain information that augments or clarifies

an operating step. Notes do not normally contain

actions. They follow the procedural steps to which

they refer.

Cautions

Cautions alert the technician to special conditions that

could injure personnel, damage equipment, or reduce

a component's mechanical integrity. Cautions are also

used to alert the technician to unsafe practices or the

need for special protective equipment or specific

materials. In this manual, a caution box indicates a

potentially hazardous situation which, if not avoided,

may result in minor or moderate injury.

Warnings

Warnings identify potentially dangerous situations or

serious hazards. In this manual, a warning indicates an

imminently hazardous situation which, if not avoided,

could result in serious injury or death.

Safety Messages

The Solitel system is rated by the IEC for use in Category

II, Pollution Degree 2 installations. Follow all standard

industry procedures for servicing electrical and computer

equipment when working with or around high voltage.

Always shut off the power supply before touching any

components. Although high voltage is not present in this

system, it may be present in other systems.

Electrical components are sensitive to electrostatic

discharge. To prevent equipment damage, observe safety

procedures when working with electrostatic sensitive

components.

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2)

This device must accept any interference received, includ-

ing interference that may cause undesirable operation.

Low Voltage Directive

For use in Category II installations. If equipment is used

in a manner not specified by manufacturer, protection

provided by equipment may be impaired.

W RNING! Explosion hazard. Do not connect or

disconnect equipment unless power has been switched off

or the area is known to be non-hazardous.

Warranty

All Magnetrol electronic level and flow controls ar

warranted free of defects in materials or workmanship

for eighteen months from the date of original factory

shipment.

If returned within the warranty period; and, upon

factory inspection of the control, the cause of the

claim is determined to be covered under the warranty;

then, Magnetrol will repair or replace the control at no

cost to the purchaser (or owner) other than transporta-

tion.

Magnetrol shall not be liable for misapplication, labor

claims, direct or consequential damage or expense arising

from the installation or use of equipment. There are no

other warranties expressed or implied, except special writ-

ten warranties covering some Magnetrol products.

Quality ssurance

The quality assurance system in place at Magnetrol

guarantees the highest level of quality throughout the

company. Magnetrol is committed to providing full

customer satisfaction both in quality products and

quality service.

The Magnetrol quality assurance system is registered to

ISO 9001 affirming its commitment to known

international quality standards providing the strongest

assurance of product/service quality available.

Performance specifications are effective with date of issue

and are subject to change without notice. Magnetrol

reserves the right to make changes to the product

described in this manual at any time without notice.

Magnetrol makes no warranty with respect to the accura-

cy of the information in this manual.