AdValue Photonics AP-ML1 사용자 설명서 - 페이지 2
{카테고리_이름} AdValue Photonics AP-ML1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AdValue Photonics AP-ML1 10 페이지. 2 micron high power mode-locked fiber laser
페이지 인쇄
1. General Safety Instructions
In order to ensure safe operation and optimal performance, please note the following
cautions and warnings:
For installations operating Class 4 laser products, a laser safety officer should be
appointed. It should be the laser safety officer's responsibility to review the following
precautions and designate the appropriate controls to be implemented. Wherever
practicable, laser protective enclosures should be used for lasers of Class 4.
Before powering on, make sure the correct [power
supply] voltage is being applied.
Always use this product in conjunction with a
properly grounded power source.
The use of optical instruments with this product
will increase eye hazard.
Use of controls, adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
This product emits invisible laser radiation around
the 2 µm wavelength. The optical output may reach
1 W average power from the output port. Please
avoid direct eye exposure to beam, and use
appropriate laser safety eyewear when operating
this product.
Exercise caution to avoid/minimize specular
reflections because the reflections at this operation
wavelength are invisible.
Do not install or terminate fibers when laser is
active.
Any and all precautions should be taken to reduce
back reflections. Damage due to back reflections
will not be covered under Warranty. Properly clean
all connectors, angle cleave bare fiber, or apply a
proper fusion splice to reduce back reflections.
2/10