Astro-Gadget EQStar+ 사용자 설명서 - 페이지 13

{카테고리_이름} Astro-Gadget EQStar+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astro-Gadget EQStar+ 15 페이지. Equatorial mount control system

object. The very same object will be in the field of view of the telescope and now you

can proceed to its observation. In the process of guidance from the object to the

object, the accuracy of the guidance may be lost. The reason for this may be the

errors of the polar axis, errors in the mechanics of the telescope, etc. Therefore, it is

recommended to periodically tie the telescope on a visible star, as described above.

6. CONTROL STAND-ALONE

(OPERATION joystick)

6.1. Follow steps 3.1, 3.2.

6.2 Connect the control unit to the mount with the joystick of the manual control.

6.3 After switching on the power, beeps will sound, that indicates that the CS is ready

for operation and will begin tracking with a stellar speed.

6.4 The switching speed of the mount is made using the joystick positions

Ra + and Ra- while holding down the Set button. Each speed selection

Is confirmed by a short sound signal according to the following scheme: 1 beep -stop,

2 - siderial, 3 - lunar, 4 - solar speed.

6.5 Switching speed correction of the mount is made with using the joystick positions

Dec + and Dec- while holding down the Set button. Every choice speed is confirmed by

a long sound signal according to the following scheme: 1 beep - x20, 2- x65, 3- x200, 4-

x500.

Figure 8