Ametek CP14 서비스 및 부품 매뉴얼 - 페이지 6

{카테고리_이름} Ametek CP14에 대한 서비스 및 부품 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ametek CP14 14 페이지. Direct drive regenerative blower

Impeller Shimming Procedure:

WARNING: This unit may be difficult to shim. Extreme care may be exercised.

Tools Needed: Machinist's Parallel Bar

Measure the Following:

Measurements (A) and (B) are made by laying the parallel bar across the housing flange face and

measuring to the proper points. Each measurement should be made at three points, and the average

of the readings should be used.

Shim Thickness = B – (A+C)/2

After the impeller installation (step #4 above) the impeller/cover clearance can be checked with feeler

gauges, laying the parallel bar across the housing flange face. This clearance should nominally be

(A-C)/2.

Vernier Caliper with depth measuring capability

Feeler gauges or depth gauge

Distance from the flange face to the housing (A)

Distance from the flange face to the motor shaft shoulder (B)

Impeller Thickness (C)

Revised – June 2016