ASTRO-MED Dash 16u 빠른 시작 매뉴얼 - 페이지 4
{카테고리_이름} ASTRO-MED Dash 16u에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASTRO-MED Dash 16u 13 페이지. Field and lab recorder
페이지 인쇄•
Four available chart formats: Design grid for number of channels. Pick to overlap some, all or none of the channels.
•
Data logger (numeric output): Select rate at which to print values.
•
Timed recording: Pick one of four charts. Select the start and end times for recording.
•
Dual Speed Recording: Select two chart speeds at which to run the paper and select either the trigger or time duration
to switch between the speeds. The most common use is recording at the first selected chart speed, utilizing waveform
triggering to change to the second chart speed for a predetermined amount of time. At that point, the recorder will
automatically switch back to the first selected chart speed, awaiting another trigger.
During real-time recording, the display will show your signals. At the same time, you can print to paper using the
[RUN / HALT] key.
The Dash 16u gives you total control over chart layout. You can set individual channel widths, channel location, grids
ON/OFF and major/minor division sizing. You are also able to suppress or enable waveform printing as well as vary the
waveform trace thickness. Further, you can overlap some or all of the channels.
DEFAULT CHARTS
RUNNING A CHART
CUSTOMIZING A CHART
[SYS]
System key used for setting up various parameters for the Dash 16u.
Design or modify an existing chart. Edit text labels. Set up data
capture and triggering. Save or recall a system set up (Zip disk).
Other system functions such as real-time clock, display colors,
defaulting settings and software upgrade.
[MODE]
Select and run any of the four available charts. Select data logger
(numeric), timed recording or dual speed mode. Select captured data
to review as well as importing and exporting data to Zip disk.
4. REAL-TIME RECORDING FUNCTIONS
5. SETTING UP CHARTS AND GRIDS
The Dash 16u has four programmable charts. They are defaulted at the factory
prior to shipping. The defaulted charts are sixteen grids, eight grids, four grids
and one grid. You may find this a convenient place to start.
At any time, you can default the charts as follows:
[SYS] [CUSTOMIZE CHART] [DEFAULT ALL CHARTS]
[MODE] [RUN CHART X] where X = 1 or 2 or 3 or 4.
Immediately, you will see the waveforms scrolling across the color display as
well as the chart paper begins to run. Use the [RUN / HALT] key to stop the
paper.
If you don't find a chart you like from one of the four charts programmed in your
Dash 16u, you can change the chart in two different ways.
•
The first is Auto-Chart: [SYS] [AUTO-CHART SETUP]
Here the Dash 16u walks you through selecting how many channels you
want and whether to overlap them or display them individually. You are
prompted to save this chart to one of the four available charts.
•
The second method is to set up each channel's grid parameters manually:
[SYS] [CUSTOMIZE CHART]... Note that the changes made will affect
the current chart that you are working with (Chart 1-4).
There are three parameters involved with displaying a channel:
Grid, waveform trace and text buffer.