Canon CN20x50 Series 운영 매뉴얼 - 페이지 19
{카테고리_이름} Canon CN20x50 Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon CN20x50 Series 33 페이지. Information display
Canon CN20x50 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (14 페이지), 운영 매뉴얼 (41 페이지)
페이지 인쇄
5 OPERATION
5-1-5. Shuttle-Shot Function
This function allows you to switch between the current zoom position and the preset zoom position at the
maximum speed.
Current zoom position
Before using shuttle-shot function, the shuttle function must be assigned to the VTR, RET, or AUX
switch of the drive unit, or the AUX1 or AUX2 switch on the zoom demand. This manual describes the
"Shtl" function assigned to the VTR switch. For details, refer to "5-6 SWITCH OPERATIONS".
Setting the shuttle memory position
The operation with the "Shtl" switch is given the priority over that with the zoom rocker seesaw. The operation
with the zoom rocker seesaw is disabled while the "Shtl" switch is pressed.
5-1-6. Speed Preset
This function allows you to call the preset zoom speed any time you zoom. Assign the "Sped" function
to the VTR, RET, or AUX switch of the drive unit, or AUX1 or AUX2 switch on the zoom demand. This
manual describes the "Sped" function assigned to the VTR switch.
1. Storing the zoom speed and direction
MEMO Switch
The "Shtl"
switch is
held down.
Max
speed
Shuttle memory position
Zoom Rocker Seesaw
"Shtl" Switch
MEMO Switch
Zoom Rocker Seesaw
"Sped" Switch
The "Shtl"
switch is
released.
Max
speed
Zoom to the position that you want to store. Keeping this
position, press the "Shtl" switch while holding down the
MEMO switch.
The "position" you stored here is different from the one
you set in "Framing Preset" mentioned later. The stored
position set here is retained even after the power is
turned off.
Operate the zoom rocker seesaw to determine the zoom
speed and direction (toward telephoto angle or widest angle)
which you want to store, and press the MEMO switch while
holding this position.
The stored zoom speed is applied to the "Framing
Preset".
E12
Previous zoom position