Canon EF 135mm f/2.8 지침 - 페이지 2

{카테고리_이름} Canon EF 135mm f/2.8에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon EF 135mm f/2.8 2 페이지. Canon camera lens user manual

페이지 인쇄

6. Infrared Index

The infrared index corrects the focus setting when using

monochrome infrared film.

Focus on the subject in MF, then adjust the distance setting by

moving the focusing ring to the corresponding infrared index mark

❻

❼

• The infrared index position is based on a wavelength of 800 nm.

• Be sure to observe the manufacturer's instructions when using

infrared film.

• Use a red filter also when you take the picture.

7. Filters (Sold Separately)

You can attach filters to the filter mounting thread on the front of

the lens.

• Use a polarizing Canon filter (52 mm).

8. Getting Better Results with Soft Focus

(1) Lighting

In general, soft focus gives better results in backlit or semi-backlit

shots. It is also a good idea to use a lens hood to avoid unwanted

effects from extraneous light in the shot.

(2) Subject foreground and background

In normal soft focus shots, you get a better result if you select

something relatively dark as the background for your subject.

Also, shot compositions that involve defocusing the foreground

are not a good idea as the defocusing effect is poor.

(3) Shooting distance

This lens gives its best soft focus effect at distances between 3

and 5 meters.

(4) Exposure

In general, exposures that are slightly higher than the correct

exposure produce a better soft-focus effect.

9. Specifications

Focal Length/Aperture

135 mm, f/2.8

Lens Construction

6 groups, 7 elements

Minimum Aperture

f/32

Diagonal

Angle of View

Vertical

Horizontal

Min. Focusing Distance

1.3 m (4.3 ft.)

Max. Magnification

0.12×

Field of View

188 × 282 mm (7.4 ×11.1 inch)

Filter Diameter

52 mm

Max. Diameter and Length

69.2 × 98.4 mm (2.8 × 3.9 inch)

Weight

390 g (13.6 oz.)

Hood

ET-65III

Lens Cap

E-52

Case

LP1016

CT1-7541-004

The lens length is measured from the mount surface to the front

end of the lens. Add 21.5 mm when including the lens cap and

dust cap.

The size and weight listed are for the lens only, except as

indicated.

Aperture settings are specified on the camera.

All data listed is measured according to Canon standards.

Product specifications and appearance are subject to change

without notice.

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause

undesired operation.

Do not make any changes or modifications to the equipment

unless otherwise specified in the instructions. If such changes

or modifications should be made, you could be required to stop

operation of the equipment.

This equipment has been tested and found to comply with the

limits for a class B digital device, pursuant to part 15 of the FCC

Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may

cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for

help.

18°

This Class B digital apparatus complies with Canadian ICES-003.

10°

15°

●

❻

❼

●

2008.5