Cojali Jaltest SST 사용자 설명서 - 페이지 7
{카테고리_이름} Cojali Jaltest SST에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cojali Jaltest SST 15 페이지. Speed sensor tester
2 Procedures
2.1 READ MODE
· ACTIVE speed sensor:
In this mode, the speed sensor is disconnected from the ECU and connected to
the Jaltest SST device to be able to check it in isolation. By turning the component
whose sensor the user wants to check, they can determine if the sensor generates
a correct signal.
1
Disconnect the speed sensor from the vehicle and connect it to the Jaltest SST
device through multipins according to the
section.
2
Turn on the device and go into
selection button of the mode (1) according to the presses described in the
table
on page 6. The
that may appear.
3
Turn the component whose sensor you want to check.
4
Signal check: When the component is turning at constant speed, the status LEDs
of the signal must flash sequentially, clockwise, and consistently.
5
Error check:
ٚ The status LEDs of the signal flash inconsistently: The sensor does not detect a
consistent turn signal.
ٚ The
short circuit error
during the execution of the test.
ٚ The
power supply error
(simulation).
Note: It is possible to repeat the test with just a short press of the selection button of the mode (1). The
device performs an error reset and starts the test again.
Active Sensor Read
Active Sensor
LED must be on, as well as the LED of the errors
LED lights up: Short circuit to power supply has occurred
LED lights up: Incorrect mode has been selected
IMAGE 1
of the
connection diagram
mode interacting with the
7
English
function