Canon EF 35-80mm f/4-5.6 III 지침 - 페이지 2
{카테고리_이름} Canon EF 35-80mm f/4-5.6 III에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon EF 35-80mm f/4-5.6 III 2 페이지. Ef zoom lenses
Canon EF 35-80mm f/4-5.6 III에 대해서도 마찬가지입니다: 렌즈 매뉴얼 (15 페이지)
페이지 인쇄
5. Hood (sold separately)
The hood can keep unwanted light out of the lens, and also
protects the lens from rain, snow, and dust. Engage the hood
attachment tabs on the lens with the tabs on the hood and
turn the hood in the direction of the arrow to secure it to the
lens
.
❻
The hood can be reverse-mounted for storage
• To mount the hood on the EF28-105mm f/4-5.6 USM and
EF28-200mm f/3.5-5.6 USM, align the hood's attachment
position mark with the red dot on the front of the lens, then
turn the hood clockwise until the lens's red dot is aligned
with the hood's stop position mark
,
❽
❾
• Part of the picture may be blocked if the hood is not
attached properly.
Specifications
Angle of view
Diagonal
Vertical
EF22-55mm f/4-5.6 USM
90°-43°
57°-25°
EF28-80mm f/3.5-5.6IV USM
75°-30°
46°-17°
EF28-80mm f/3.5-5.6V USM
75°-30°
46°-17°
EF28-90mm f/4-5.6 USM
75°-27°
46°-15°10'
EF28-90mm f/4-5.6II USM
75°-27°
46°-15°10'
EF28-200mm f/3.5-5.6 USM
75°-12°
46°-7°
EF28-105mm f/4-5.6 USM
75°-23°20'
46°-13°
EF35-80mm f/4-5.6 USM
63°-30°
38°-17°
CT1-7516-006
6. Filter (sold separately)
The filter screws onto the front of the lens.
• Only one filter may be attached.
• If you need a polarizing filter, use Canon's PL-C polarizing
filter.
.
The lens length is measured from the mount surface to the
❼
front end of the lens. Add 21.5 mm when including the lens
cap and dust cap.
The size and weight listed are for the lens only, except as
indicated.
.
Product specifications and appearance are subject to
change without notice.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changes or modifications should be made, you could be
required to stop operation of the equipment.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generated, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled
"Digital Apparatus", ICES-003 of the Industry Canada.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques (de la classe B) prescrites dans le Règlement
sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.
Lens
Minimum
construction
aperture
Horizontal
22 mm:0.08X/295 × 454 mm (11.6"×17.9")
79°-36°
9-9
22-32
55 mm:0.2X/122 × 181 mm (4.8"×7.1")
28 mm:0.098X/255 × 393 mm (10"×15.5")
65°-25°
10-10
22-38
80 mm:0.257X/91 × 135 mm (3.6"×5.3")
28 mm:0.098X/255 × 393 mm (10"×15.5")
65°-25°
10-10
22-38
80 mm:0.257X/91 × 135 mm (3.6"×5.3")
28 mm:0.10X/245 × 367 mm (9.7"×14.4")
65°-22°40'
8-10
22-32
90 mm:0.30X/81 × 121 mm (3.2"×4.8")
28 mm:0.10X/245 × 367 mm (9.7"×14.4")
65°-22°40'
8-10
22-32
90 mm:0.30X/81 × 121 mm (3.2"×4.8")
28 mm:0.08X/312 × 485 mm (12.3"×19.1")
65°-10°
12-16
22-36
200 mm:0.28X/87 × 130 mm (3.4"×5.1")
28 mm:0.07X/365 × 566 mm (14.4"×22.3")
65°-19°20'
9-10
22-32
105 mm:0.19X/127 × 190 mm (5.0"×7.5")
35 mm:0.116X/212 × 328 mm (8.3"×12.9")
54°-25°
8-8
22-32
80 mm:0.247X/97 × 144 mm (3.8"×5.7")
Min. focusing
Max. magnification and field of view
distance
0.35 m/1.15 ft
0.38 m/1.25 ft
0.38 m/1.25 ft
0.38 m/1.25 ft
0.38 m/1.25 ft
0.45 m/1.5 ft
0.48 m/1.57 ft
0.38 m/1.25 ft
© CANON INC. 2006
❻
●
❼
●
Filter diameter
Hood
Max. diameter and length
58 mm
EW-60D
66 × 59.4 mm (2.6"×2.3")
58 mm
EW-60C
66.4 × 71.2 mm (2.6"×2.8")
58 mm
EW-60C
66.4 × 71.2 mm (2.6"×2.8")
58 mm
EW-60C
67 × 71 mm (2.6"×2.8")
58 mm
EW-60C
67 × 71 mm (2.6"×2.8")
72 mm
EW-78D
78.4 × 89.6 mm (3.1"×3.5")
58 mm
EW-63B
67 × 68 mm (2.6"×2.7")
52 mm
EW-54
65 × 61 mm (2.6"×2.4")
❽
●
1
2
❾
●
Weight
Case
175 g/6.2 oz
LP1014
200 g/7.0 oz
LP814
200 g/7.0 oz
LP814
190 g/6.7 oz
LP814
190 g/6.7 oz
LP814
500 g/17.6 oz
LP1116
210 g/7.4 oz
LP814
170 g/6.0 oz
LP814
2006.9.1