Canon EF LENS TS-E24MM F/3.5L 사용 설명서 - 페이지 4

{카테고리_이름} Canon EF LENS TS-E24MM F/3.5L에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon EF LENS TS-E24MM F/3.5L 21 페이지. Ef lens
Canon EF LENS TS-E24MM F/3.5L에 대해서도 마찬가지입니다: 사용 설명서 (19 페이지), 사용 설명서 (24 페이지), 사용 설명서 (13 페이지), 사용 설명서 지침 (35 페이지)

페이지 인쇄

a Safety Precautions

1. Do not look at the sun or a bright light source

through the lens or camera. Doing so could result in

loss of vision. Looking at the sun directly through the

lens is especially hazardous.

2. Whether it is attached to the camera or not, do not

leave the lens under the sun without the lens cap

attached. This is to prevent the lens from concentrating

the sun's rays, which could cause a fire.

a Handling Cautions

If the lens is taken from a cold environment into a

warm one, condensation may develop on the lens

surface and internal parts. To prevent condensation in

this case, first put the lens into an airtight plastic bag

before taking it from a cold to warm environment. Then

take out the lens after it has warmed gradually. Do the

same when taking the lens from a warm environment into

a cold one.

ENG-2

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Do not make any changes or modifications to the equipment

unless otherwise specified in the instructions. If such changes or

modifications should be made, you could be required to stop

operation of the equipment.

This equipment has been tested and found to comply with the

limits for a class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for

help.

This digital apparatus does not exceed the Class B limits for radio

noise emissions from digital apparatus as set out in the

interference-causing equipment standard entitled "Digital

Apparatus", ICES-003 of the Industry Canada.