Cola MARY 설치, 사용 및 유지 관리 매뉴얼 - 페이지 6

{카테고리_이름} Cola MARY에 대한 설치, 사용 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cola MARY 12 페이지. Wood-burning stove with oven

페이지 인쇄

1.8 Ordering replacement parts

For the end-user: Contact the service centre and/or your dealer to request any replacement parts.

For the dealer: To request any replacement parts contact the Cola s.r.l. service centre and/or send a fax clearly

specifying the following data:

stove model;

serial number;

date of purchase;

list of replacement parts;

details of faults encountered.

- Operations on parts must be carried out by authorised and/or qualified personnel.

- Only use original Cola replacement parts.

1.9 Stove decommissioning

For disposal, the stove must be sealed inside strong packing; contact the local authority in charge of such

operations in order to proceed according to the current local regulations.

2 – TRANSPORT AND INSTALLATION

2.1 Packing, handling, shipment and transport

The stove can be lifted using a lift truck, inserting the forks (of suitable length) in the special spaces in the

wooden packing.

Make sure the equipment used for lifting and transport can take the weight of the stove, specified on the

dataplate and in this manual.

Avoid taking the load in areas where it could be a danger if dropped.

Set the stove down on the floor carefully without bumping, and position it in the required place; make sure the

floor can take the weight of the stove, otherwise consult a specialised technician.

2.2 Instructions for safe installation

The stove must be installed by a technician, taking into account the local, national and European regulations.

The unit must be placed on a floor able to take its weight; otherwise corrective measures can be taken

according to the advice of specialised technicians. Flammable parts or those sensitive to heat must not be kept

near the glass, as this zone becomes hot. The minimum front distance for the protection of flammable objects is

80 cm. The minimum side distance and that of the rear wall from flammable parts or those sensitive to heat is

20 cm. If the support base is made of flammable material (wood, cork, etc.) a protection base in 2-3 mm thick

steel plate or a sheet of toughened glass must be provided.

2.3 Connection to the flue

The MARY stove must be connected to the flue with connection supports located at the top of the stove body

and by means of flue pipes readily available on the market. Connection to the chimney must be made using

strong and stable pipes, with recommended minimum thickness of 1.2-2 mm. The flue pipe must possibly be

straight, to avoid pressure losses, and towards the flue. The individual parts of the flue pipe must be sealed.

To ensure regular operation, the flue draught with stove operating must be between 10 and 14 Pa.

For optimum stove efficiency, a draught control or

Every unit must eliminate the fumes through its own flue; never use the same flue for several units.

2.4 Room ventilation

The air necessary for combustion, i.e. up to 20 m³ every hour, must be ensured in rooms where stoves with

natural flue draught are installed. The air change must occur through several fixed openings to the outside,

whose cross section must comply with the current local regulations. Such openings must be protected with

grilles and must never be obstructed.

If the air is insufficient, even the operation of an extractor hood in the room or exhaust fans can negatively affect

stove operation.

damper must be fitted in the

flue pipe or chimney.

Mary