FlyingThingZ Indy Sport Car .40 조립 설명서 - 페이지 7

{카테고리_이름} FlyingThingZ Indy Sport Car .40에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FlyingThingZ Indy Sport Car .40 20 페이지. A sport scale flying race car

A7. Carefully insert the forward servo tray between the two

fuse sides. Make sure the back end butts up against the fuselage

cross brace, then glue into place.

A8. Slide the hatch bolt plate against the firewall. Line up the

flaps flush against the top of the firewall and clamp down as the

glue sets. Make sure the hatch bolt plate is on top of the fuselage.

A9. To prepare the rear part of the fuselage, use the rear servo

tray as a spacer and clamp down the two fuselage sides. DO NOT

glue the rear servo tray at this time, it is only being used as a

spacer.

A10. Size and cut a hatch tongue plate and glue it to the notch-

es on the back of the fuselage. Sand the edges flush with the sides

of the fuselage. Sand the rearward part of the hatch tongue plate

to match the angle of the fuselage as shown in the image above.

A11. Glue the rear fuselage hatch plate to the back of the fuse-

lage. Sand the top of the fuselage rear plate flush with the hatch

tongue plate. Leave a 1/8" overhang on the bottom of the rear

fuse plate.

A12. Cut two pieces of balsa triangle to fit flush with the top

of the firewall. Glue the triangle onto the hatch bolt plate and the

sides of the fuselage and firewall