COLAMY A420 사용 설명서 - 페이지 3
{카테고리_이름} COLAMY A420에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. COLAMY A420 5 페이지.
페이지 인쇄ASSEMBLY INSTRUCTIONS
Remove the Velcro from under the Seat(2). Connect Seat(2) to Back Cushion(1) using one
Step 1
Allen Bolt M8*80mm(A), one Flat Washer(D), and one Spring WasherE) for each corner
hole; use one Bolt M8*55mm(C), one Flat Washer(D), and one Spring Washer(E) for the
central hole. Tighten all bolts with a Wrench(F), starting at 50%.
A
Bolt M8*80mm *4
(For Back Legs)
C
Bolt M8*55mm *1
D
Flat Washer *5
E
1
Spring Washer *5
F
Wrench *1
To attach Front Legs(3), use a flat washer(D), spring washer(E), and Bolt M8*60mm(B) for
Step 2
each hole. Tighten the screws to 50% using the wrench(F). Adjust the balance of the chair,
and then tighten all bolts to 100% with the wrench(F).
Refer to Step 2 of "ATTENTION" in the manual.
Note: The side where the black tape is applied is the side where the screws are tightened.
B
Bolt M8*60mm *4
(For Front Legs)
D
D
E
Flat Washer *4
E
F
Spring Washer *4
1
F
Wrench *1
3
2
C
A
50%
tighten
B
ASSEMBLY INSTRUCTIONS
Step 3
F
A
E
D
ATTENTION
Please read the following instructions to help you assemble the dining chair faster.
Step 1
Step 2
3
Step 3
Finally, attach the Seat Base Cover (4) back onto the underside of the chair seat using
Velcro. Your chair is ready for use.
50%
1. Partly screw in bolts, but do not fully
tighten
tighten.
Put pressure on the seat.
(About 44lbs/20kg)
2. Place the chair on a flat surface and
apply pressure to the seat. Firstly tighten
the middle bolt on the back, then both
bolts on the sides, and finally the front
legs. Make sure all bolts are fully tightened
before using the chair.
3. lf the legs are uneven, you can also
adjust the foot pegs at the bottom
of the legs to improve balance.
4
100%
tighten
4