Astrohog IP0032 매뉴얼 - 페이지 11
{카테고리_이름} Astrohog IP0032에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astrohog IP0032 18 페이지.
페이지 인쇄IP Phone Manual
The IP Phone's default setting is NAT mode. If you don't need to use the NAT
Mode, you can chang to Bridge Mode. If you change the setting to Bridge
Mode, then the LAN setting will not effect and will be the same as WAN port.
The WAN port default is DHCP Client mode, You can change the setting to
Fixed IP Mode, or PPPoE Mode.
If you change the WAN port's setting to Fix IP Mode, then you have to make
sure the IP address. Net Mask, Gateway, and DNS setting is suitable in your
current network environment.
If you change the WAN port's setting to PPPoE Mode, you have to input a
correct username/password to get the IP address from your Internet Service
Provider.
When you finished the setting, please click the Submit button.
If there is nothing need to change, please click the Save Change Item in the
left side, then click the Save button. The change you made will save into the
system and the system will Reboot automatically.
20
IP Phone Manual
4.
LAN Settings: In this page you can configure the IP Phone LAN port's setting.
The LAN port's default IP address is 192.168.123.1, Net Mask is 255.255.255.
0., and DHCP Server enabled. The start IP address if 150, end IP adress is 200.
It is not necessary to change the LAN settings.
You can connect your PC to the LAN port, set your PC as DHCP Client mode,
then you can get IP address from the phone.
When you finished the setting, please click the Submit button.
If there is nothing need to change, please click the Save Change Item in the
left side, then click the Save button. The change you made will save into the
system and the system will Reboot automatically.
21