Astromi.ch MGPBox 매뉴얼 - 페이지 7

{카테고리_이름} Astromi.ch MGPBox에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astromi.ch MGPBox 20 페이지.

MGPBox can either be used with or without a computer.

If you use the RJ10 interface of MGPBox, please check the pinout of your mount's computer

before hookup. We take no responsibility for possible damages resulting from improper

configurations! Please see Chapter

Usage with computer



Connect MGPBox to your computer using the supplied USB-Cable and launch the

application. MGPBox will be recognized by Windows as a new Com-Port



It is recommended to do this at least once to in order to configure the behavior of the

RJ10 Port.



On older Windows Versions or other Operating Systems, it might be necessary to install

the proper FTDI Driver before the device becomes available.

Usage without computer



MGPBox can also be connected to your mount using the supplied RJ10 cable. The

RJ10-Port is configured similar to a serial port and MGPBox can draw power either thru

the USB-Port or from the RJ10-Port.



Using just the RJ10 Port makes MGPBox operate in stand-alone mode where it just

keeps sending data according to its configuration.

Note: For 10Micron Mounts, if the mount is powered off but the mount's power source

remains on, MGPBox will continue to receive power from the mount.

Please consult the respective manual for a description of the windows application.

MGPBox usage

"RJ10

Interface" for details

Page 7

Version 1.1