Coldelite UC-113G 매뉴얼 - 페이지 9

{카테고리_이름} Coldelite UC-113G에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coldelite UC-113G 17 페이지. Gravity soft serve freezers

5) Repeat the above procedure for the second beaterlauger

assembly.

Rotate the beater/auger until you feel the drive shaft engage

6) Finally, insert the beaterlauger into the freezer cylinder.

Halding the beaterlauger horizontally, slide it straight into

the cylinder until it can go no further.

IMPORTANT: Before installing the beaterlauger, make certain

the beater lip seal is in place and the idler is properly

7) Insert the second beaterlauger. Once installed, make certain

the flat portion of the idler is in a vertical position. The idlers

should spin freely and are counter weighted to naturally rest

in a vertical position.

B) Assembling the Dispensing Head

1) Begin by gathering all the parts necessary to assemble the

dispensing head. These parts include: A) two (2), 4" diameter

O-rings, B) the dispending head<body, C) the center piston

O-ring, D) four (4), 1 3/d' diameter end piston O-rings, E)

center piston, F) two (2) end pistons, G) handle retaining

rod. H) three (3) dispense handles.